Rollease Acmeda Automate
The Rollease Acmeda Automate integration allows you to control and monitor covers via your Rollease Acmeda Automate hub. The integrations communicates directly with hubs on the local network, rather than connecting via the cloud or via RS-485. Devices are represented as a cover for monitoring and control as well as a sensor for monitoring battery condition.
Supported devices
- Automate Pulse Hub v1
Configuration
To add the Rollease Acmeda Automate integration to your Home Assistant instance, use this My button:
If the above My button doesn’t work, you can also perform the following steps manually:
-
Browse to your Home Assistant instance.
-
In the bottom right corner, select the Add Integration button.
-
From the list, select Rollease Acmeda Automate.
-
Follow the instructions on screen to complete the setup.
Multiple hubs
Multiple hubs work transparently with discovery, so you don’t have to do anything special to set them up.
Caveats
If the IP address for the hub changes, you will need to re-register it with Home Assistant again. To avoid this, you may set up a DHCP reservation on your router for your hub so that it always has the same IP address.
The integration has the following limitations:
- covers with position as well as tilt are not supported.
- the integration doesn’t make use of rooms and scenes configured in the hub, use the equivalent functionality in Home Assistant instead.