Pentair ScreenLogic


The Pentair ScreenLogic integration allows you to integrate your Pentair IntelliTouch or EasyTouch pool controller with Home Assistant via the Pentair ScreenLogic gateway.

Configuration

To add the Pentair ScreenLogic integration to your Home Assistant instance, use this My button:

Pentair ScreenLogic can be auto-discovered by Home Assistant. If an instance was found, it will be shown as Discovered. You can then set it up right away.

Options

ScreenLogic options are set via Settings -> Devices & Services -> Pentair ScreenLogic -> Options.

-= Seconds between scans - How many seconds between each polling of the ScreenLogic gateway.

Services

screenlogic.set_color_mode

Sets the operation of any connected color-capable lights.

Service data attribute Optional Description
target no An area containing the ScreenLogic device, the ScreenLogic device itself, or any entity from the ScreenLogic device you wish to set the color mode on.
color_mode no The color mode to set. Valid values are listed below.

Reference

Color Modes

color_mode Name Description
all_off All Off Turns all light circuits off.
all_on All On Turns all light circuits on to their last mode.
color_set Color Set Sets light circuits to their pre-set colors as set in the pool controller.
color_sync Color Sync Synchronize all IntelliBrite, SAm, SAL, or FIBERworks color changing lights and synchronize their colors.
color_swim Color Swim Cycles through white, magenta, blue and green colors. (Emulates Pentair SAm color changing light.)
party Party Rapid color changing building the energy and excitement.
romance Romance Slow color transitions creating a mesmerizing and calming effect.
caribbean Caribbean Transitions between a variety of blues and greens.
american American Patriotic red, white and blue transition.
sunset Sunset Dramatic transitions of orange, red and magenta tones.
royal Royal Richer, deeper, color tones.
save Save Color Save the exact colors that are being displayed.
recall Recall Color Recall the saved colors.
blue Blue Fixed color: Blue
green Green Fixed color: Green
red Red Fixed color: Red
white White Fixed color: White
magenta Magenta Fixed color: Magenta
thumper Thumper Toggles the solenoid thumper on MagicStream laminars.
next_mode Next Mode Cycle to the next color mode.
reset Reset Reset light modes.
hold Hold Hold light transitions.